TRAVELER 4all Ergo & 4you Ergo usage instructions
27
To
attach the clothing guard
, this is first
mounted on the back jointed shaft with the rear
side section mount and then the front side
section mount is inserted in the "side section
mount, bolted".
Figure 55: Rear side section mount mounted on
back jointed shaft (view without drive wheel)
21.3 Adjusting the clothing guard
position
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
After adjusting the drive wheel position or in-
stalling different tyres on the drive wheels, it
may be necessary to adjust the position of the
clothing guard on the wheel arch. The distance
between the tyres and the clothing guard
should be between 5 and 8 mm to avoid pinch-
ing your fingers, scraping the tyres on the
clothing guard, and obstruction when grasping
the handrim.
To adjust the clothing guard position, loosen
the four M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Figure 56: Clothing guard mount
Figure 57: M5 fixing screws and slots in the side
section mounts
Now the front and back side section mounts
can be positioned along the slots in the cloth-
ing protection guard and the side section
mounts. In doing so, ensure that the side sec-
tion mounts can be smoothly inserted back
onto the back jointed shaft and into the side
section mounts.
Finally the clothing guard mounts are posi-
tioned accordingly and the M5 fixing screws
(AF 3 mm) are screwed back into the clothing
guard mounts with 6 Nm.
Figure 58: Slots of the clothing guard
Slots of the clothing guard
M5 fixing screws
Slots of the side
section mount
Clothing guard
mount
