TRAVELER 4all Ergo & 4you Ergo usage instructions
57
27.2 Aluminium push handles fixed in
back tube
Figure 163: Aluminium push handles fixed in back
tube
It is not possible to adjust these push handles.
To
remove
the push handles, undo the M6
fixing screw (AF 4 mm) with washer on both
sides. The push handles can then be pulled
out from the back tubes.
To
install
the push handles, place these in the
back tube and insert the M6 fixing screws (AF
4 mm) (with washers) into the each of the
holes of the back tube and push handle. Tight-
en the M6 fixing screws (AF 4 mm) to 11 Nm
torque and secure them with thread-locking
fluid.
27.3 Push handles, horizontally
screwed in back tube
Figure 164: Push handles, horizontally screwed in
back tube
It is not possible to adjust these push handles.
To
remove
the push handles, turn these coun-
ter-clockwise out of the back tube.
Figure 165: Screw the push handle horizontally out
of the back tube
To
install
the push handle, turn it into the back
tube clockwise and tighten it to a maximum
hand tightness.
27.4 Safety push handles with contin-
uous height adjustment
Figure 166: Safety push handles with infinite height
adjustment
For
adjusting the height
of the push handles,
open the clamp lever by turning counter-
clockwise (a half to a complete rotation). Then
the height of the push handles can adjusted.
The height can be infinitely adjusted. We rec-
ommend adjusting both push handles to the
same height. Once the desired height is set,
hold the push handles in this position and then
close the clamp lever again clockwise with a
half to complete rotation.
M6 fixing screw with washer
Screwing out
Open
Close
Clamp lever
