TRAVELER 4all Ergo & 4you Ergo usage instructions
66
4. The helpers then stand on the next step
down and repeat the process until they
reach the end.
5. The user can help the descent by breaking
on the handrim.
31 Malfunctions
In the event of any malfunctions which cannot
be repaired by yourself based on the usage
instructions included in the scope of delivery,
please contact your rehabilitation specialist
dealer or PRO ACTIV directly.
Malfunctions must be repaired before any
further use or, if they occur during the trip, it
must be interrupted immediately.
All serious incidents that have occurred in con-
nection with the product must be reported to
the manufacturer and the responsible authority
in the state in which the user resides.
32 Cleaning and care
Regularly cleaning the product is prescribed to
prevent the components from becoming stiff
due to soiling. In particular, the product should
be carefully cleaned after every major use, e.g.
summer or winter holidays.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive environmen-
tal influences. If this cannot be avoided, the
product must always be cleaned immediately
after such use, and moving parts must be
greased. Regular cleaning prevents corrosion
and increased wear.
In case the product becomes wet when using,
dry it after use.
Clean the quick release axles of the drive
and caster wheels as well as the ball bearings
and grease them with a little lubricating oil with
high corrosion protection properties (e.g. Ne-
oval MTO 300) approx. every 8 weeks in order
to guarantee the reliable functioning properties.
Clean your product with water, solvent or
neutral cleaning agents. To prevent scratching
or fading of the coating or the anodised parts,
do not use any abrasive cleaning agents or
aggressive, acidic cleaners. Only use water
and soap to clean the seat and backrest up-
holstery.
The product must not be cleaned using
steam or high pressure.
Recommended care:
If you need care products for your product,
please contact PRO ACTIV.
33 Maintenance
33.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following in-
structions about maintenance.
If repairs are required or there are any
defects in your product, in the interests of your
own safety, you should contact your rehabilita-
tion specialist dealer or PRO ACTIV before
using it again and have the defect remedied.
Screws and other elements need to be se-
cured properly again after repairs.
For tyres with tread: As soon as there is
one or more points with less than 1
mm of
tread on the tyres, the tyres must be changed
as otherwise there is an increased risk of an
accident.
For tyres without tread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible, the tyres must
be changed as otherwise there is an increased
risk of an accident.
