WHEEL-E usage instructions
16
Figure 12: Parking stand in the active position
Figure 13: Parking stand in the passive position
20.1.2 Parking stand height adjustment
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
The height adjustment of the parking stand is
important in order to bring the docking plate of
the product to the correct (height) position
relative to the adapter.
For setting the height of the parking stand, the
following must be observed: the dimension
from the floor to the lower edge of the front of
the insertion maul (on the wheelchair side)
should correspond with the dimension from the
ground to the upper edge of the insertion bolt
(on the product side). As soon as there is a
deviation from these two dimensions due to the
hole pattern, the dimension from the ground to
the upper edge of the insertion bolt may be up
to max. 1 cm larger. In this case, the product
can be inserted into the adapter by tipping
slightly to the rear (via the parking stand).
Figure 14: Measurement from the ground to the
lower edge of the front of the towing attachment
Figure 15: Dimension from the ground to the upper
edge of the insertion bolt
Front of
the towing
attachment
Dimension
from the
ground to
the lower
edge of the
front
Insertion
bolt
Dimension from
the ground to
the upper edge
of the insertion
bolt
