2
Remove the outboard set of screws from the
sections using a wrench, slide extension
section into each end to complete a 12' run,
install and tighten the screws to secure.
Attach the Track Supports, and Track Riser
Supports to the track.
Note:
Track Supports offers rigidity and
prevent dolly from running off the rails.
The track is now ready to use.
Remove the lock knob from the 27" central
section and connect the 32" dolly rods to give
it a triangular shape.
Attach the 27" rod to the wheelset and
tighten the knob to secure.
Track
Setup
Loosen the lock knob from the 32" rods of the
dolly section, connect with 27" of central area,
and tighten the knob to secure.
Attach the 14" central support system rod to
the base and tighten the screws to secure it.
Swift Dolly
Setup
E to E
C to C
