i
INTRODUCTION
Read and understand this entire manual regarding the rules for users’
safety before installing, operating, or servicing the equipment.
A procedure, which if not properly followed, may cause injury to the
operator or others in the operating area
Equipment identification
Receipt of equipment
The identification number (specification or part number), model, and serial
number of this unit usually appear on a nameplate attached to the control panel;
record these numbers for future reference.
When you receive the equipment, check it against the shipping documents.
Make sure it is complete and inspect the equipment for possible damage
during shipping. If there is any damage, notify the carrier immediately to file a
claim.
Furnish complete information concerning damage claims or mistakes in
shipment to United ProArc Corporation
：
No. 3 Gungye 10
th
Road, Pingjen
Industrial Park, Pingjen City, Taoyuan 324, Taiwan. Include the quipment
identification number along with a description of the parts in question.
Move the equipment to the installation site before uncrating the unit. Use care
to avoid damaging the equipment when using bars, hammers, etc. to uncrate
the unit.
Falling machine due to lifting device failure may cause death or injury.
﹡
Lifting device may fail when overloaded.
﹡
Avoid sudden jerks, drops or swinging.
﹡
Check lifting device components visually for looseness and signs of metal
fatigue.
﹡
Before changing any hardware, check grade and size of bolts, and replace
with bolts of equal or higher size and grade. Additional copies of this manual
may be purchase by contacting United ProArc Corporation.
﹡
Before operating, be sure to adjust correct input voltage.
WARNING
WARNING
WARNING
Summary of Contents for PT-1000
