Probasics PB6074, Owner'S Operation And Maintenance Manual

12

SECTION 5— MAINTENANCE

WARNING

After 

ANY

 adjustments, repair or service and BEFORE use, make sure 

that all attaching hardware is tightened securely - otherwise injury or 

damage may result.

REPLACING THE BACK CUSHION

NOTE:

 For this procedure, refer to 

FIGURE 5.1

.

REMOVING

1.    Remove the four long hex screws that secure the back cushion to  

the back frame.

2.    Remove the four short hex screws that secure headrest bracket to 

the back cushion.

3.    Repeat for remaining headrest bracket.

INSTALLING

1.   Align back cushion with the back frame.

2.    Install four long hex screws to secure the back cushion to the back 

frame. Securely tighten.

3.    Secure the headrest bracket to the back cushion with four short hex 

screws.

4.   Securely tighten. Repeat for remaining headrest bracket.

FIGURE 5.1

   Replacing the Back Cushion 

REPLACING THE FOOTREST CUSHION

WARNING

NEVER

 stand on the footrest or seat when entering or exiting the 

recliner. The recliner will tip and bodily injury may occur.

NOTE: 

For this procedure, refer to 

FIGURE 5.2

 on page 13.

1.    Recline the recliner to raise the footrest assembly. Refer to Reclining 

the Chair on page 10.

2.    Remove the four hex screws that secure the existing footrest 

cushion to the recline mechanism.

3.    Align the four mounting holes of the recline mechanism with the 

four mounting holes of the new footrest cushion.

4.    Using four hex screws, secure the footrest cushion to the recline 

mechanism.

Headrest Bracket

Short Hex Screws

Back Frame

Cushion

Long Hex

Screws