INDEX
1. Warnings....................................................................................................................2
2. Installation...............................................................................................................3-4
3. Raising and Lowering Rails.........................................................................................5
4. Limited Lifetime Warranty.......................................................................................5-6
WARNING
IMPORTANT! READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING OR USING
PROBASICS MODEL 7035 CLAMP-ON HALF RAIL. IF YOU DO NOT UNDERSTAND ANY PART OF
THESE WARNINGS, CAUTIONS OR INSTRUCTIONS, CONTACT A HEALTHCARE DEALER FOR DI-
RECTION IN THE USE OF THIS PRODUCT. IF THESE CLAMP-ON HALF RAILS ARE NOT PROPERLY
INSTALLED AND ADJUSTED, PERSONAL INJURY AND/OR DAMAGE TO THE CLAMP-ON HALF
RAIL COULD RESULT.
For information on Bed Rail Safety, please see the following brochure:“A Guide to Bed Safety: Bed
Rails in Hospitals, Nursing Homes and Home Health Care: The Facts ” on the FDA website, at…
http://www.fda.gov/cdrh/beds/
• The Probasics 7035 Clamp-On Half Rail is designed for use in the homecare setting.
• If components are damaged or missing, contact your dealer immediately.
DO NOT
use
substitute parts. Use only Probasics replacement parts. Non Probasics replacement parts
could cause entrapment, personal injury, and/or damage to the Clamp-on Half Rails.
• The Probasics 7035 Clamp-On Half Rail has no weight limitation when used with a manual
or electric homecare bed. The Clamp-On half Rail is intended to define the edge of the
sleep surface and to help prevent an individual from inadvertently rolling or climbing out
of bed. Do not use the Clamp-On Half Rail as a restraint. In an individual is capable of
injuring himself/herself, consult a physician for alternative means of safe restraint.
• Compass Health Brands assumes no responsibility for any damage or injury caused by
improper installation or use of this product.
INSTALLATION
Note: Clamp-On Half Rail may be installed on either head deck angle or foot deck angle
.
The Clamp-On Half rail cannot be installed on pan deck.
Movable Clamp Disassembly
- Probasics Clamp-On Half Rail, as shipped, is shown
below. Before installation, you must remove and disassemble the moveable clamp.
Unscrew the knob from the
moveable clamp assembly to
separate the knob and threaded
clamp, as shown at left.
Knob
Clamp
Retainer Bar
Homecare
Clamp-On Half Rail
Mounting Slot
Retainer Hook
2
3
