ESC Programming Procedure
1. Pull and hold the Throttle Trigger to full throttle and turn
the ESC on.
2. After 2 seconds a
“-B-B”
will sound. Wait another 5
seconds and the ESC will give a rising tone to indicate you
have entered
Programming Mode
.
3. After entering Programming Mode, you will hear 4 tones
in a loop to indicate
Programmable Items
. Push the
Throttle Trigger to full brake within 3 seconds to select the
programmable item.
4. After selecting a programmable item, you will hear several
tones in a loop to indicate
Programmable Values
. Pull
Throttle Trigger to full throttle to select the value matching
the tone. The ESC will give an alternating tone to indicate
the item is selected.
5. Keep the Throttle Trigger at Full Throttle to return to
Step
3
and continue item selection. Move the Throttle Trigger
to full brake position within 2 seconds to exit the Program
Mode.
The black-shaded setting is the factory default
Programmable Items
Programmable Value
-B
Single Beep
B––
Long Beep
-B
-B-B
-B-B-B
-B-B-B-B
B––
B––
-B
B––
-B-B
B––
-B-B-B
Running Mode
-B
Forward Only
Forward/
Backward
Li-Po Cells
-B-B
Auto Calc.
2s
3s
4s
5s
6s
Low Voltage Cutoff
-B-B-B
None
2.8V/Cell
3.0V/Cell
3.2V/Cell
3.4V/Cell
Timing
-B-B-B-B
0.00º
3.75º
7.50º
11.25º
15.00º
18.75º
22.50º
26.25º
Motor Care
INSTRUCTION MANUAL
9
EN
Brushless motors are maintenance free; however, the
bearings that support the rotating portion of the motor
require regular service.
Tip:
Removing the motor can make servicing it easier.
1. Remove the cage (see
Removing the Cage
).
2. Replace the propeller (see
Replacing the Propeller
).
3. Use water displacement fluid on the motor bearings to
flush any water from the motor compartment.
4. Apply 1–2 drops of Dynamite Precision Oiler on the front
and rear bearings, one at a time.
5. Turn the motor by hand to allow the oil to work its way
into the ball bearing through the bearing seal.
6. Install the propeller and cage in reverse.
Tip:
Preventing overheating conditions will prolong motor life.
To remove the boat cage:
NOTICE:
Carelessly removing the cage from the hull may
sever the wire that powers the LED mounted to the cage.
1. Disconnect and remove the battery from the boat.
2. Secure the boat with one hand and carefully lift the cage
from the hull.
3. Disengage the 10 cage posts from their base and carefully
remove the remainder of the cage.
Tip:
If you need to remove the cage, disconnect the LED
wire from the receiver. Use a 2mm hex driver to remove
the 4 screws securing the electronics cover.
4. To reinstall the cage, follow the instructions in reverse.
Removing the Cage
