background image

ShockWave

®

 26

15

EN

Country of  

Purchase

Horizon Hobby

Contact Information

Address

United States of 

America

Horizon Service Center

(Repairs and Repair Requests) 

servicecenter.horizonhobby.

com/RequestForm/

4105 Fieldstone Rd  

Champaign, Illinois, 61822 USA

Horizon Product Support

(Product Technical Assistance)

productsupport@ 

horizonhobby.com

877-504-0233

Sales

websales@horizonhobby.com

888-338-4639

European Union

Horizon Technischer Service

service@horizonhobby.eu

Hanskampring 9 

D 22885 Barsbüttel, Germany

Sales: Horizon Hobby GmbH

+49 (0) 4121 2655 100

Warranty and Service Contact Information

EU Compliance Statement: 

Horizon 

Hobby, LLC hereby declares that this 

product is in compliance with the essential 

requirements and other relevant provisions of the RED 

and EMC Directives.  

A copy of the EU Declaration of Conformity is available 

online at: 

http://www.horizonhobby.com/content/support-

render-compliance

.

Instructions for Disposal of WEEE by 

Users in the European Union

This product must not be disposed of with other 

waste. Instead, it is the user’s responsibility to dispose of 

their waste equipment by handing it over to a designated 

collection point for the recycling of waste electrical and 

electronic equipment. The separate collection and recycling 

of your waste equipment at the time of disposal will help to 

conserve natural resources and ensure that it is recycled in 

a manner that protects human health and the environment. 

For more information about where you can drop off your 

waste equipment for recycling, please contact your local city 

office, your household waste disposal service or where you 

purchased the product.

FCC Information

FCC ID: 2AI3D-SS0001  

This device complies with 

part 15 of the FCC rules. Operation is subject to the 

following two conditions: (1) This device may not cause 

harmful interference, and (2) this device must accept any 

interference received, including interference that may 

cause undesired operation.

CAUTION: 

Changes or modifications not 

expressly approved by the party responsible for 

compliance could void the user’s authority to operate 

the equipment. 

This product contains a radio transmitter with wireless 

technology which has been tested and found to be 

compliant with the applicable regulations governing a radio 

transmitter in the 2.400GHz to 2.4835GHz frequency range.
This equipment has been tested and found to comply with 

the limits for Part 15 of the FCC rules. These limits are 

designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio 

communications.
However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, 

which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and 

receiver.

• Connect the equipment to an outlet on a circuit 

different from that to which the receiver is connected.

IC Information

IC ID: 21682-SSTC9202  

This device complies with Industry 

Canada licence-exempt RSS standard(s). Operation is 

subject to the following two conditions: (1) this device may 

not cause interference, and (2) this device must accept 

any interference, including interference that may cause 

undesired operation of the device.

Antenna Separation Distance

When operating your 

Spektrum transmitter, 

please be sure to maintain 

a separation distance of at 

least 20 cm between your 

body (excluding fingers, 

hands, wrists, ankles and 

feet) and the antenna to 

meet RF exposure safety requirements as determined by 

FCC regulations.
The following illustrations show the approximate 20 cm RF 

exposure area and typical hand placement when operating 

your Spektrum transmitter.

Summary of Contents for Shockwave 26



















Reviews: