29
Operations
Lower Control Panel
1.
Lubrication Cup
The lubrication cup allows lubricant spray to reach
the vacuum blower.
2.
Warm Water Outlet
The warm water outlet allows the cleaning techni-
cian to drain warm water from the water box for
mixing chemical.
3.
Water Inlet
This quick connect allows the water supply hose to
be connected to the unit.
4.
Engine Oil Drain
The engine oil drain plug is removed to allow the
engine oil to be drained.
5.
Solution Outlets
The solution outlets are the connecting point for the
high pressure solution hoses. These outlets are
quick disconnects that allow hoses to be plugged
into the unit.
6.
Pressure System Valve (Option)
This lever when in the up position actuates the
high-pressure system and regulator. When in the
down position the low pressure cleaning system
and regulator are actuated.
7.
High Pressure Solution Regulator (HP Only)
The high pressure regulator sets the pressure of
the pressure washing circuit. This spring loaded
valve can be adjusted up or down. The pressure is
increased by turning the valve clockwise, or
reduced by turning the valve counterclockwise.
(This valve must be maintained in accordance with
this manuals maintenance table.)
8.
High Pressure Solution Outlet (Option)
The high-pressure solution outlet is the connecting
point for the high-pressure washing hose. This
outlet is a quick disconnect that allows the
pressure washing hose to be plugged into the unit.
9.
Low Pressure Solution Regulator
The pressure regulator sets the pressure of the
solution system. This spring loaded valve can be
adjusted up or down. The pressure is increased by
turning the valve clockwise, or reduced by turning
the valve counterclockwise. (This valve must be
maintained in accordance with this manuals main-
tenance table.)
10. Solution Screen
The solution screen is located on the front of the
machine. The function of this screen is to trap
foreign particles from exiting the machine and
plugging the orifices of the cleaning tools. This
screen is part of the machine maintenance
cleaning.
11. Chemical Check Valve
The chemical check valve allows chemicals to
enter the system and travel in a singular direction
to the wand. The chemical check valve prevents
chemicals from traveling upstream into the solution
system of the unit.
12. Temperature Balance Orifice
The temperature balance orifice helps to balance
and stabilize the solution temperature within the
system.
13. Solution Temperature Control Lever
This lever directs hot engine and blower exhaust
gases through or around the heat exchangers.
86411100 Manual Operators - Everest E-Idle Prochem
