CR2 Manual 29/03/21
Page 15 of 29
Assembling the accessory racks:
The CR2 is shipped with the accessory racks and hardware in the solution tank. When you receive your CR2, it is
necessary to secure the racks to the body. The only tool required to complete the assembly is a Phillips head
screwdriver.
The CR2 comes equipped with threaded inserts pre-installed in the body. The two larger racks are installed toward
the front of the machine- one per side and the two smaller racks are installed toward the rear, also one per side.
Opening the machine
:
This unit can be opened by simply removing two bolts located on the back of the machine. The unit will open
forward by lifting up on the handle. If you need to open the unit further, you may release the vacuum hose going
from the base of the vacuum plate to the bottom of the recovery tank by loosening the hose clamp at the base of
the recovery tank.
