6
PLG025b
ENGLISH
UNPACKING
WARNING:
If any parts are missing, do not operate this tool until the missing
parts are replaced. Failure to do so could result in serious personal injury.
Carefully remove the product from the carton.
Inspect the product to make sure no breakage or damage occurred during
shipping.
Do not discard the packing material until you have inspected and operated the
product.
The Pro-Concept PLG025 Gas Trimmer is supplied with the following accessories:
Trimmer assembly
Front handle assembly
Grass guard assembly
String head
ASSEMBLY
Attaching the Front Handle (Fig. 1)
Remove the front handle, bolt, flat washer, lock washer and wing nut from box.
Attach the front handle onto the shaft and snap into place. Locate the front
handle to a comfortable position.
Slide the bolt through the front handle.
NOTE:
The hex bolt head fits inside the hex recess molded into one side of the
handle.
Install the flat washer, lock washer, and wing nut.
Tighten wing nut securely.
Debris shield (Fig. 2)
The debris shield must be installed to properly dispense trimming line and protect
the operator.
NOTE:
Shield fits snuggly onto the shaft. Some effort may be required to attach it
correctly.
Seat shield onto shaft bracket.
Insert bolt through hole. Bolt head should fit into the hex shape in shield.
Insert washer and nut. Tighten securely.
FUEL
Gas Trimmer Fuel Mixture
WARNING:
Never use straight gasoline in your unit. This will cause permanent
engine damage and void the manufacture’s warranty for that product. Use regular
grade unleaded gasoline mixed with 2-cycle engine oil in 40:1 ratio for best
results. Never use a fuel mixture that has been stored for over 60 days.
GASOLINE - The lowest recommended octane rating is 90. If you run the engine
on gasoline with a lower octane rating than 90 so-called “knocking” can occur.
This leads to an increased engine temperature which can result in serious engine
breakdown.
1.
2.
3.
4.
5.
1.
2.
3.
!
!
OPERATING INSTRUCTIONS
Fig. 1
Fig. 2
Debris shield
Shaft bracket
