83
Note: winterizing
is not mandatory,
particularly in clement
climates where
temperatures remain
positive year round.
In this case, keep the
water at the correct
level and run the
filter for 2 to 3 hours
per day. Check the
water level in the pool
regularly.
WATER TREATMENT & MAINTENANCE OF THE FILTRATION SYSTEM
To ensure the comfort of pool users, you will need to treat the pool water. Follow
the recommendations concerning operation of the filtration group: commissioning,
frequency of use for regeneration of the water, maintenance, inspections (pipes, nuts
and bolts), etc. Monitor the build up of dirt in the sand filter (see the section on filter
back washing).
During the pool season, the filter should be run every day for long enough to
renew the entire pool water volume at least three times every 24 hours.
To ensure optimal efficiency of the filtration system, make sure that the water
level remains correct and constant. The water level should be 2/3 of the way up the
skimmer mouth.
To fill your pool, use tap water, its pH is close to the ideal pH. If you use water
from a well or some other private source you must have it analysed beforehand.
You will need to test the pH of your pool at regular intervals and adjust it if necessary
to keep it between 7.2 and 7.6. Treatment chemicals for this purpose are widely
available.
To preserve the quality of the pool water, it will need to be tested and treated
regularly. Frequency will depend on a number of conditions; pool situation, bather
load, weather conditions, etc.
As pool water cannot be directed into the sewage system, it must be directed
as rain run-off. Familiarise yourself with the regulations concerning disposal of pool
waste water in effect in the area in which the pool is located.
WINTERIZING THE POOL
Carry out a prolonged back wash of the filter.
The pool should not be emptied during winter (or prolonged periods while the
pool is not use). The liquid mass plays a several roles, providing thermal insulation,
holding the liner and pool structure in position.
Lower the water level to about 10 cm below the bottom of the skimmer mouth.
Water can be siphoned from the pool or allowed to drain by gravity by moving he
multiport valve to DRAIN. Water will run through the waste line. Do not run the pump
during this operation.
Next, disconnect the pipe underneath the skimmer so that it can act as an over-
flow in the event the water level rises due to precipitation. Remove any water treat-
ment chemicals from the skimmer (chlorine tablets, flocculants, etc.).
Unscrew the return fitting face ring from inside the pool.
Use a threaded winterizing plug or rubber plug (not provided) to block the return
fitting from inside the pool.
Add an algaecide and a winterizing product (not supplied) to the water.
Remove the stainless steel ladder.
Place a winter cover over the surface of the pool.
WINTERIZING THE HYDRAULIC INSTALLATION
Disconnect the return line.
Allow water to drain from the suction and return lines.
Open the plug at the bottom of the filter and allow water to drain away. Do not
replace the plug before putting the filter back into service.
Open the drain plugs on the pump and pre-filter.
Leave the plugs open.
Cut the power supply to the filtration control panel.
In as far as possible, store the filtration group in a location protected from humid-
ity. In the case of an unprotected outdoor installation, remove the pump and store it.
We think that we have provided you with main information you required to use
and maintain your pool, however you will find more information in specialised guides
and reviews. Don’t hesitate to consult these.
impOrtaNt :
make sure that the
filtration apertures
are not blocked.
in the event of
damage to the
filtration system,
take steps to prevent
access to the pool.
replace damaged
components as
quickly as possible.
Only use parts
approved by our
after sales service.
