5
4.
For the cordless model, ensure the
kettle is correctly engaged on its
base.
See Illustration 1.
5.
Plug in kettle.
6.
Make sure that the red “boil”
trigger situated under the handle
is switched on (down).
See
Illustration 2 for the Cord-Free
model and Illustration 3 for the
Corded model.
7.
The kettle will switch off automati-
cally when the water has boiled.
(Remember, the surface of the
kettle gets hot; take care–only
grip the kettle by the handle.)
IMPORTANT:
Ensure that the
cordless kettle has switched off
automatically or is switched off
manually before removing it from
the base.
8.
Unplug kettle before pouring.
9.
If you want to refill the kettle
immediately, first check the
water level indicator and then,
if required, run cold water in
through the spout.
10.
After use, unplug the kettle and
empty.
NOTE:
Never leave a hot kettle
unattended when there are children about.
4
The length of the cord used on this appliance was selected to reduce
the hazards of becoming tangled in, or tripping over a longer cord.
If a longer cord is necessary an approved extension cord may be
used. The electrical rating of the extension cord must be equal to or
greater than the rating of the kettle. Care must be taken to arrange
the extension cord so that it will not drape over the countertop or
tabletop where it can be pulled on by children or accidentally tripped
over.
WARNING:
To avoid burns and reduce risk of personal injury, use
extreme caution when carrying kettle containing hot water. Do not
pour in the direction of people or over people.
CONSUMER SAFETY INFORMATION
(CONT.)
Using the 1.7 L Automatic Kettle
Before First Use:
Fill kettle to maximum capacity and bring
to a boil until kettle shuts off automatically. Discard water and
repeat. Rinse out the kettle two or three times.
NOTE:
Use water only in the kettle. If used for foods or
beverage such as tea or coffee, the warranty will be voided.
1.
Unplug kettle before filling.
2.
Fill kettle with desired amount of water. Make sure to cover
the element. The water level must be between minimum
and maximum indicator lines on the water level indicator.
WARNING:
If kettle is overfilled there is a risk that boiling
water may spit out of the spout.
3.
Make sure that the lid is in place and the kettle or power
base (cordless models only) is standing on a level surface.
If the lid is not in place auto shut-off will not operate.
All kettle cords must be kept away from hot surfaces.
Illustration 1
Illustration 2
Illustration 3
