3
avoid a hazard. Contact Customer Service for information on examination,
repair, or adjustment as set forth in the Limited Warranty.
12.
The use of attachments not recommended or sold by the appliance
manufacturer may cause fire, electric shock, or personal injury.
13.
Do not use your food processor if any part is broken.
14.
Do not use outdoors.
15.
Do not let cord hang over edge of table or counter or touch hot surfaces,
including stove.
16.
Do not place on or near a hot gas or electric burner, or in a heated oven.
17.
Check that the appliance is OFF ( ) before plugging cord into wall outlet.
To disconnect, turn the control to OFF ( ); then remove plug from wall
outlet. To unplug, grasp the plug and pull from the outlet. Never pull from
the power cord.
18.
Be sure to turn switch to OFF ( ) position after each use. Always use the
pushers to clear the feed chute. When this method is not possible, unplug
cord from outlet and disassemble unit to remove the remaining food.
19.
Be certain lid is securely locked in place before operating appliance.
20.
Never feed food into feed chute by hand. Always use the food pushers.
21.
Do not attempt to defeat any interlock mechanism.
22.
To reduce the risk of injury, never place cutting blade or disc on base
without first putting bowl properly in place.
23.
Make sure the blade or disc has come to a full stop before removing lid.
24.
Do not use appliance for other than intended purpose.
25.
The appliance is not intended for commercial, professional, or industrial
use. It is designed and built exclusively for household use only.
26.
Never use appliance for a longer period or with a larger amount of
ingredients other than that recommended by appliance manufacturer.
27.
Be careful if hot liquid is poured into the food processor bowl as it can be
ejected out of the appliance due to a sudden steaming.
28.
Do not fill the bowl above the marked maximum fill line (or rated capacity)
to avoid risk of injury due to damage to the cover or bowl.
29. CAUTION!
In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
