59
•
Sensitivity level [1-100]:
The default level is 80, which means if
20% or more sampling pixels are
detected differently, system will detect motion. The bigger the value, the
more sensitive it is. Meanwhile,
when the value is bigger, the red
horizontal line in the motion indicati on window will be lower accordingly.
•
Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each
detected motion.
Triggered Action (Multi-option)
The Administrator can specify alarm ac tions that will take when motion is
detected. All options are listed as follows:
•
Enable Alarm Output
Check the item and select the predef ined type of alarm output to enable
alarm relay output when motion is detected.
•
Record stream to SD Card
Select this item, and the Motion Detection recording will be stored in
Micro SD/ SDHC card w hen motion is detected.
NOTE:
Please make sure the local recording (with Micro SD/
SDHC card) is activated so that
this function can be implemp-
lemented. See section
5.3.12 Recording
for further details.
•
Send Alarm Message by FTP/E-Mail
The Administrator can select whet her to send an alarm message by
FTP and/or E-Mail when motion is detected.
•
Upload Image by FTP
Select this item, and the Administ rator can assign a FTP site and
configure various parameters as shown in the figure below. When
motion is detected, event images will be uploaded to the appointed FTP
site.
