Prodigy
r
Manual Powder Spray Gun
15
Part 1053680E05
E
2007 Nordson Corporation
Control Cable Replacement
(contd)
6. See Figure 18. Remove the end cap
screw (21) and end cap (20) from the gun body.
20
21 21
Figure 18
Removing the End Cap
7. See Figure 19. Disconnect the multiplier
connector (J2) from the multiplier receptacle.
8. Remove the post and lock washer (17, 16) to
disconnect the ground terminal (GND).
J2
GND
17
16
Figure 19
Disconnecting the Control Cable
9. See Figure 20. Lift up on the back of the gun
body (14) to unsnap it from the handle, then
push the body forward to separate it from the
handle (23).
Feed cable
through here
14
23
Figure 20
Separating the Gun Body from the Handle
10. Feed the ground and multiplier wiring through
the opening in the handle.
11. Perform the previous steps in reverse to install
a new cable.
Resistor and Electrode Replacement
Resistor and Electrode Removal
1. See Figure 15. Unscrew the lock knob (7) and
pull the powder tubing out of the adapter (9).
2. See Figure 21. Loosen the set screw (5) in the
bottom on the adapter.
5
9
Figure 21
Loosening the Adapter Set Screw
