Prodigy
r
Manual Powder Spray Gun
17
Part 1053680E05
E
2007 Nordson Corporation
Multiplier Replacement
Removal
1. Remove the resistor holder. Refer to steps 1-4
of the Resistor and Electrode Replacement
procedure.
2. Remove the end cap and disconnect the control
cable. Refer to steps 6-8 of the Control Cable
Replacement procedure.
3. Push the multiplier out of the gun body from the
front.
4. See Figure 27. Remove the contact spacer
(18) from the multiplier well. Clean the
dielectric grease off the contact spacer.
18
Figure 27
Removing the Contact Spacer
Assembly
1. See Figure 27. Insert the contact spacer into
the multiplier well. Fill the multiplier well with
dielectric grease.
2. Install the multiplier into the gun body.
3. Fill the resistor holder well with dielectric
grease. Refer to Resistor and Electrode
Installation instructions.
4. See Figure 23. Screw the resistor holder onto
the multiplier.
5. See Figures 22 and 21. Install the adapter over
the electrode and resistor holders. Tighten the
set screw.
6. See Figure 19. Connect the ground wire to the
gun body with the lockwasher and post.
Connect the multiplier connector (J3) to the
multiplier receptacle.
7. See Figure 18. Install the end cap on the gun
body with the screw.
8. See Figure 15. Push the powder tubing into the
adapter until it bottoms out against the powder
tube, then thread the lock knob into the adapter
and tighten it snugly.