7. Adjustments
Normally, the force settings are automatically set, and the adjustment is unnecessary. However,
the force can be adjusted by an authorized professional opener installer for special purposes if
it is necessary.
7.1) Press SET and hold, the LED will display a setting number from 1 to 3, release SET, it
is now in force adjustment mode.
7.2) Press UP to increase the force one-degree, and press DOWN to decrease one degree
(maximum degree is 9 and the minimum is 1).
7.3) Press SET button to confirm.
7.4) When the door is hindered, it will rebound 15 --20cm.
8. Self Learning Transmitter
10.1) Press CODE, release until the LED displays
.
. Press a button on the transmitter, then
release and press again, the dot will flash to confirm the code. Success!
10.2) Repeat step 1 to code a maximum of 20 different transmitters’ and/or buttons.
10.3) To delete all stored codes, press and hold CODE, the LED displays dot flash .,keep more than
8 seconds until the LED display C, all the settings of the transmitters are deleted
9. Function Modes
The unit has two selectable functioning modes, PHOTO BEAM, AUTO CLOSE DOOR and LOCK
DOOR.
9.1) PHOTO BEAM:
Make sure the photo beam has been installed correctly before setting the PHOTO BEAM
function.
9.1.1) Press DOWN and hold until the LED displays
–
, then LED displays
H
or
||
automatically
according to the original state.
9.1.2) If the LED displays
H
, press DOWN once, the LED displays
||,
the photo beam is now
disabled.
If the LED displays
||,
press UP once, the LED displays
H
, the photo beam is now enabled.
9.1.3) Press SET to confirm and quit.
