Profi-pumpe 5 001 001 008, Operating Instructions Manual

4 English

7. PERFORMANCE OF THE PUMP

The performance of the pump depends on the orientation of the solar panels towards the sun and their intensity. The 

max. Performance is achieved under optimum conditions. A function in the shade or under cloudy skies can not be 

guaranteed. The solar pond kits are designed primarily for use in the summer months. However, the solar panel power 

should be enough even on days in spring and autumn with excellent sunlight to operate. However, this can not be gua

-

ranteed. For models with battery operation the function of the solar pond sets the charge state of the battery depends.

Depending on the pump version allows you to customize the delivery. If a controller is available at the pump, as in the 

horizontal position is the max. achieved delivery. In a vertical position only little or no water is pumped. This model sets 

the flow rate at the control panel of the battery case.

8. BATTERY INFORMATION

After 12 to 18 months, you should replace the battery. For this purpose unscrew the battery cover and replace the 

battery with a new (replacement batteries available on request). Please note the limited implied warranty of 6 months.

Tools needed:

Medium sized Philips head screwdriver.

1. Remove the srews from battery box

2. Remove the lid and control panel from the battery box slightly.

3.  Disconnect the old battery from the control panel and remove it from the  

housing. Insert the new battery.

4. Carry out the assembly in reverse order.

IMPORTANT! It must be ensured that the battery cover is properly  

tightened and watertight.

With repeated charge and discharge cycles Lead-Acid and NiMh battery 

packs are less efficient (memory effect). This effect is much less pronounced, 

but still present in small mass in the Li-ion batteries used.

Through very short and frequent loading operations and many 

other operational influences batteries can age prematurely strong. 

The batteries are therefore subject to a consumable and wearing  

part of a shortened warranty of 6 months.

If you find that the battery will be less efficient, the battery needs 

to be fully charged. These allow the unit for 2 to 3 days (pump should 

not be connected) standing in the sun in order to  

allow a maximum charge the battery or use a suitable external  

charger. We recommend to occasionally repeat this procedure to extend the battery life.

If after this recharging the battery still does not meet expectations, you should replace the batteries.

NOTE: The battery is supplied charged. If the state of charge, contrary to expectations, not be sufficient to 

charge the batteries for at least 8 hours to allow sufficient charging of the battery (so damage the battery to 

avoid overcharging, the pump must be connected).

6.2 Operation from remote control

 IMPORTANT!

You have to press the POWER button in battery

box to switch on battery system first, then you

can select function by pressing button on the

remote control.

l

  (ON):

The Pump will be constantly on until battery runs out of all power.

l

  (2):

The pump will stay on for 2 hours an then switch off for 22 hours and will repeat this timing set every day at the 

same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 2 hours timer at 

5pm. Pump will turn on every day at 5pm and turns off at 7pm.

l

  (3):

The pump will stay on for 3 hours an then switch off for 21 hours and will repeat this timing set every day at the 

same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 3 hours timer at 

5pm. Pump will turn on every day at 5pm and turns off at 8pm.

l

  (4):

The pump will stay on for 4 hours an then switch off for 20 hours and will repeat this timing set every day at the 

same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 3 hours timer at 

5pm. Pump will turn on every day at 5pm and turns off at 9pm.

Lid

Battery

connector (black)

Battery

Control panel

Battery box

Screws /4pc)

Battery

connector (red)