Proflex X-Lite Series User Manual Download

Page: 10 / 13

X-Lite Series Electric Treadmill

E&OE

Care, Maintenance and Troubleshooting

Some maintenance activities described may be beyond the scope of some users. For

procedures that you are not comfortable with or have the tools or experience for, have the

unit serviced by a service centre or qualified technician. • To prevent electrical shock, switch OFF and unplug

the equipment before cleaning or performing any maintenance tasks. • Before each use, check the running

belt for wear.

Cleaning

The equipment can be cleaned with a soft cloth and mild detergent. Do not use abrasives, solvents or harsh

chemicals. Be careful not to get excessive moisture on the display panel as this may damage it and create

an electrical hazard.
After each use, wipe the unit of any sweat, dirt or liquids. Pay extra attention to the edges of the belt, where it

meets the running boards on each side of the running belt – keeping this area clean will help prolong the life

of the unit and maintain its performance. Keep the equipment, especially the display console, out of direct

sunlight to prevent damage to the screen.

Storage

Store the equipent in a clean and dry indoor environment. Never leave or use the unit outdoors. Ensure the

master power switch is OFF (“O”) and the power cord is un-plugged from wall outlet.

Troubleshooting

Problem

Potential Reason

Correction

Equipment will not start.

. Equipment not plugged in.

. Safety tether not in place.

. Equipment circuit breaker tripped.

. Plug power cord to electrical outlet

and switch ON.

. Place safety tether in correct location

on console.

. Wait 5 minutes and then try to restart

the equipment.

No console display.

No connection.

Check electrical cables are in good

condition and properly connected.

Belt slips.

Belt loose.

Adjust belt tension.

Belt hesitates when stepped

on.

. Not enough lubrication on running

deck.

. Belt too tight.

. Lubricate running deck.

. Adjust belt tension.

Belt is not centred.

Running belt tension not even across the

rear roller.

Adjust belt alignment.

Equipment unsteady

Surface not flat.

Set-up equipment on a flat surface. • If

applicable, rotate feet under front of

machine to move up or down as needed

so equipment is steady.

When to Call for Help

This equipment is designed with user safety as a priority. In the event of electrical failure, the equipment will

shut off automatically to prevent injury and damage to the unit. If you encounter unusual behaviour from the

equipment, turn the power switch off and on to reset the equipment. This should ready the equipment for

normal operation again. If after you have reset the equipment that it is still not operational, call an authorized

service centre or technician for servicing.

HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX HPF PROFLEX