7
5. Identify the Right Handlebar (48), which is
marked with an “R” sticker.
See the inset drawing.
While a second person
holds the Right Handlebar (48) near the Upright
(3), tie the pull wire to the right Pulse Wire (71),
and pull it into the side of the Upright and out of
the top. Then, untie and discard the pull wire.
Slide the Right Handlebar (48) onto the Upright
(3). Attach the Right Handlebar with two M6 x
38mm Button Bolts (53), two M6 Split Washers
(43), and two M6 Locknuts (54).
Make sure that
the hexagonal holes are in the indicated
location.
Attach the Left Handlebar (47) in the same
way.
Orient the Water Bottle Holder (49) as shown.
Insert the Upper Wire Harness (32) and the
Pulse Wires (71) through the Water Bottle
Holder. Then, slide the Water Bottle Holder onto
the Upright (3) and attach it with an M4 x 16mm
Screw (40).
Do not tighten the Screw yet.
5
4
4. While another person holds the Upright (3) near
the Frame (1), connect the Upper Wire Harness
(32) to the Lower Wire Harness (31).
Tip: Avoid pinching the wire harnesses.
Gently pull the upper end of the Upper Wire
Harness (32) to remove the slack, and slide the
Upright (3) onto the Frame (1). Attach the
Upright with four M8 x 20mm Patch Screws (35)
and four M8 Split Washers (36).
35
35
36
36
36
32
31
36
48
54
43
53
32
71
71
49
47
Hexagonal
Holes
40
3
3
1
Avoid pinching the
wire harnesses
Pull
Wire
Pull
Wire
71
All manuals and user guides at all-guides.com
