14
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise bike regu-
larly. To clean the exercise bike, use a damp cloth and
a small amount of mild detergent;
never use abra-
sives or solvents to clean the exercise bike. To
avoid damaging the console, keep liquid away
from the console.
CONSOLE TROUBLESHOOTING
If the console does not function properly, replace all
the batteries at the same time. See assembly step 7
on page 8 for battery installation instructions.
ADJUSTING THE BELT
The exercise bike features a precision belt that must
be kept properly adjusted. If the belt is too tight, the
bearings may be damaged; if the belt is too loose, the
fan may be damaged. If the belt causes excessive
noise or slips as you pedal, follow the steps below.
Carefully remove the four Guard Clips (76), the left
Guard Fastener (35), and the Left Guard (13).
See the
inset drawing.
Press downward on the Belt (22).
There should be no more than 3/4 in. (2 cm), and
no less than 1/4 in. (0.6 cm), of vertical movement
in the center of the Belt.
If the Belt (22) needs to be adjusted, first loosen the
right Guard Fastener (not shown). To tighten the Belt,
turn the M6 Nuts (53) clockwise; to loosen the Belt,
turn the M6 Nuts counterclockwise.
See the drawing at the left.
Make sure that the Fan
(5) is straight, and then reattach the Left Guard (13),
tighten the Guard Fasteners (35), and reattach the
Guard Clips (76).
35
76
76
13
76
5
22
22
53
