7
4. Attach the Seat (20) to the Seat Post (6) with
four M8 Locknuts (66) and four M8 Split
Washers (72).
Note: The Locknuts and Split
Washers may be preattached to the under-
side of the Seat.
4
20
72
66
6
5.
Tip: To avoid pinching the Reed Switch Wire
(31), position it as shown in the inset
drawing.
Apply a small amount of the included grease to
the Handlebar Axle (33). Insert the Handlebar
Axle into the Frame (1) and center it.
5
31
1
Grease
33
Avoid pinching the
Reed Switch Wire (31)
6
6. While another person holds the Upright (2) near
the Frame (1), connect the Reed Switch Wire
(31) to the Extension Wire (39).
Tip: Do not pinch the Reed Switch Wire (31)
or the Extension Wire (39).
Set the Upright (2)
on the Frame (1). Attach the Upright with three
M10 x 17mm Screws (55) and three M10 Split
Washers (54).
55
54
54
55
2
1
39
31
31
33
1
