ProForm 310 E Elliptical, Manual

9

7

7.  Untie and discard the wire tie on the Main 

Wire (42).

While a second person holds the Console (4) 
near the Upright (2), connect the wires on the 
Console to the Main Wire (42) and to the Sensor 
Wires (93). 

Insert the excess wire into the Upright (2) or into 
the Console (4). 

Tip: Avoid pinching the wires.

 Attach the 

Console (4) to the Upright (2) with four M4 x 
16mm Screws (92).

4

42

92

2

93

4

Battery 

Cover

Battery 

Cover

6

 6.  The Console (4) can use four D batteries (not 

included); alkaline batteries are recommended. 
Do not use old and new batteries together or 
alkaline, standard, and rechargeable batter-
ies together. 

IMPORTANT: If the Console has 

been exposed to cold temperatures, allow it 
to warm to room temperature before inserting 
batteries. Otherwise, you may damage the 
console displays or other electronic com-
ponents.

 Remove the battery covers from the 

back of the Console, and insert batteries into the 
battery compartments. 

Make sure to orient the 

batteries as shown by the diagrams inside 
the battery compartments.

 Then, reattach the 

battery covers.

To purchase an optional power adapter, call 
the telephone number on the cover of this 
manual. To avoid damaging the console, 
use only a manufacturer-supplied power 
adapter.

 Plug one end of the power adapter into 

the receptacle inside the battery compartment 
on the console; plug the other end into an outlet 
installed in accordance with all local codes and 
ordinances.

Avoid pinching 

the wires

8

8.  Orient the Rear Console Cover (81) as shown.

Have a second person hold the Rear Console 
Cover (81) against the Upright (2) until you com-
plete step 9.

2

81

Receptacle