9
7
7. Untie and discard the wire tie on the Main Wire
(42).
While a second person holds the Console (4)
near the Upright (2), connect the wires on the
Console to the Main Wire (42) and to the Sensor
Wires (93).
Insert the excess wire into the Upright (2) or into
the Console (4).
Tip: Avoid pinching the wires.
Attach the
Console (4) to the Upright (2) with four M4 x
16mm Screws (92).
4
42
92
2
93
4
Battery
Cover
Battery
Cover
6
6. The Console (4) can use four D batteries
(not included); alkaline batteries are recom-
mended.
IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Remove the battery covers from the back of the
Console (4), and insert batteries into the battery
compartments.
Make sure to orient the bat-
teries as shown by the diagrams inside the
battery compartments.
Then, reattach the bat-
tery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console, use
only a manufacturer-supplied power adapter.
Plug one end of the power adapter into the
receptacle on the console; plug the other end
into an outlet installed in accordance with all
local codes and ordinances.
Avoid pinching
the wires
8
8. Orient the Rear Console Cover (81) as shown.
Have a second person hold the Rear Console
Cover (81) against the Upright (2) until you com-
plete step 9.
2
81
Summary of Contents for 395E
Page 24: ...24 NOTES...
