9
7. Route the Upright Wire (28) through one of the
Handrails (18) as shown, and remove the wire tie
from the Upright Wire.
Attach the Handrail (18) to the Right Upright (36)
with two 5/16" X 2 1/4" Bolts (20) and two 5/16"
Star Washers (19).
Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright
(31) with two 5/16" X 2 1/4" Bolts (20) and two
5/16" Star Washers (19).
31
28
Wire Tie
20
19
18
20
19
18
7
28
18
8. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
Handrail with a 1/2" Ground Screw (11).
Connect the wire harness on the Console Base
(26) to the Upright Wire (28).
See the inset
drawing. The connectors should slide to-
gether easily and snap into place.
If they do
not, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
11
26
Ground
Wire
28
Wire
Harness
8
22
9. Insert the wires into the Console Base (26) as
you set the Console Base on the Handrails (18).
Be careful not to pinch the wires.
Next, thread
two 1/4" X 1/2" Bolts (22) with 1/4" Star Washers
(21) into the Handrails and the Console Base;
do
not tighten the Bolts yet.
Attach the Console Base (26) to the Handrails
(18) with four 3/4" Screws (2).
Then, tighten the
two 1/4" X 1/2" Bolts (22).
2
22
21
21
2
18
18
9
26
Front View
36
