ProForm 695e, User Manual

9

14.

Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware
may be left over after assembly is completed. 

To protect the floor or carpet from damage, place a mat

under the elliptical crosstrainer.

13. Refer to the inset drawing. Apply a small amount of

the included Teflon

¨

lubricant to a paper towel; rub a

thin film of the lubricant onto each of the Chrome
Tubes (21). Slide an Upper Body Arm (7) onto each
Chrome Tube. 

Make sure that the Upper Body Arms

are turned as shown.

Tap a 5/8Ó Axle Cap (85) onto one end of the Axle
(19). Insert the Axle through one of the Upper Body
Arms (7) and then through the Upright (2). Slide the
other Upper Body Arm (7) onto the Axle. Tap another
5/8Ó Axle Cap (85) onto the Axle.

19

2

13

21

Lube

4

7

85

7

7

85

12. Apply a small amount of grease to the axle on the left

Crank Arm (6). 

Slide a Nylon Washer (11) and the Left Pedal Arm (3)
onto the axle on the left Crank Arm (6). Note: It may be
helpful to use a rubber mallet to tap these parts on. 

Be

careful not to confuse the Left Pedal Arm with the
Right Pedal Arm (not shown); look at the position
of the round tube to identify the Left Pedal Arm.

Next, tap a 3/4Ó Axle Cap (61) onto the axle. 

Attach the Right Pedal Arm (not shown) in the same way.

6

Grease

11

61

3

12

Round Tube