3. Cut the plastic tie off the bracket on the base of each
Upright (82). Next, cut the plastic tie off the Left Handrail
(74). Position the Left Handrail on the left Upright (82).
The bracket on the base of the left Upright should be
in-
side
of the lower end of the Left Handrail, as shown in
inset drawing C.
Refer to inset drawing A. While a second person holds the
Right Handrail (85) and the Console (not shown) near the
right Upright (82), cut the indicated plastic ties off the
Right Handrail.
Do not cut the other plastic tie in the
Right Handrail.
Next, cut the plastic tie off the Upright
Wire Harness (34) in the right Upright (82).
Do not drop
the Upright Wire Harness into the right Upright.
Refer to inset drawing B. Connect the Console Wire Harness
(48) to the Upright Wire Harness (34). The latch on the
Console Wire Harness should snap onto the Upright Wire
Harness.
If the Wire Harnesses do not fit together easily,
turn them; do not force the Wire Harnesses together.
Plastic Tie
74
82
Plastic
Tie
3
48
34
Plastic
Ties
A
B
34
48
85
82
Do not
cut
Bracket
74
C
1. With the help of a second person, carefully raise the
treadmill to the upright position. While the other person
tips the treadmill to one side and holds it, insert one of
the Extension Legs (103) into the treadmill. Make sure
that the Extension Leg is turned so the Warning Decal
(20) is on top. Tighten two of the four Short Screws
(101) into the treadmill and the Extension Leg.
Next, tip the treadmill to the other side and attach the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
1
20
101
103
5
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench
and your own phillips screwdriver , adjustable wrench and scissors .
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow step 2 to lower the treadmill.
Next, attach the latch support to the center hole in the left
Upright (82) with a 3/4Ó Screw (81).
Make sure that the
Screw is tight, but do not overtighten it; if the Screw is
overtightened, the latch will not slide smoothly.
Remove the tape from the Latch Assembly (77).
Be care-
ful to hold the parts together.
Inset drawings A and B
shows how the parts fits together. Make sure that the
tabs on the latch are touching one side of the bracket and
the back end of the latch is flush with the other side of the
bracket. Then, insert the two springs into the bracket.
Attach the Latch Assembly (77) to the left Upright (82)
with two 3/4Ó Screws (81).
77
81
81
82
2
Flush
Bracket
A
B
Latch
Support
Latch
Spring
Spring
Tabs
