ProForm 831.297793, User Manual

2. Refer to HOW TO LOWER THE TREADMILL FOR USE

on page 14. Follow step 2 to lower the treadmill.

Attach the latch support to the center hole in the left Upright
(82) with a 3/4Ó Screw (81) as shown. 

Make sure that the

Screw is tight, but do not overtighten it; if the Screw
is overtightened, the latch will not slide smoothly.

Remove the tape from the Latch Assembly (77). 

Be care-

ful to hold the parts together.

Inset drawings A and B

show how the parts fits together. Make sure that the tabs
on the latch are touching one side of the bracket and the
back end of the latch is flush with the other side of the
bracket. Then, insert the two springs into the bracket. 

Attach the Latch Assembly (77) to the left Upright (82)
with two 3/4Ó Screws (81).

77

81

81

82

2

Flush

Bracket

A

B

Latch

Support

Latch

Spring

Spring

Tabs

1. With the help of a second person, carefully raise the

treadmill to the upright position. While the other person
tips the treadmill to one side and holds it, insert one of the
Extension Legs (103) into the treadmill. Make sure that
the Extension Leg is turned so the Warning Decal (20) is
on top. Tighten two of the four Short Screws (101) into the
treadmill and the Extension Leg. 

Next, tip the treadmill to the other side and attach the other
Extension Leg (not shown) in the same way. Lower the
side of the treadmill so that both Extension Legs (103) are
resting flat on the floor.

20

101

103

1

ASSEMBLY

Assembly requires two people.

Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed.

Assembly requires the included allen wrench

and your own phillips screwdriver                       , adjustable wrench                       and scissors                   .

3. Cut the plastic tie off the bracket on the base of each

Upright (82). 

Next, cut the plastic tie off the Left Handrail (74).
Position the Left Handrail on the left Upright (82). The
bracket on the base of the left Upright should be 

inside

of the lower end of the Left Handrail, as shown in the
inset drawing.  

Plastic

Tie

74

82

Plastic

Tie

82

3

Bracket

74

6