ProForm colling breeze 495Pi, User Manual

6

ASSEMBLY

Assembly requires two persons.

Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches       and your own phillips screwdriver                             ,
rubber mallet                    , and adjustable wrench                            .

For help identifying the assembly hardware, see the drawings below. 

If a part is not in the parts bag, first

check to see if it has been pre-assembled.

1.

Make sure that the power cord is unplugged.

With the help of another person, carefully raise the
Upright (69) to the vertical position. Insert one of the
Extension Legs (63) into the treadmill as shown. (Note: It
may be helpful to tip the Upright as you insert the
Extension Leg.) Make sure that the Base Pad (61) is
under the Extension Leg. 

Insert the other Extension Leg (63) in the same way.

!

!

3/4” Screw (2)–2

Wheel Nut (32)–2

2” Bolt (64)–2

Silver Ground

Screw (75)–1

1” Tek Screw (39)–6

Handrail Bolt (37)–4

1/2” Screw (48)–10

69

63

61

1