7
4. Make sure that the Cable Connector Nut (76) is
threaded all of the way onto the Cable Connector
(75). Align the slot in the Cable Connector Nut with
the slot in the Cable Connector. See drawing 4a.
Insert the tip of the Lower Tension Cable (74) into the
indicated opening. Pull down on the Lower Tension
Cable and insert it into the Cable Connector Nut. Turn
the Cable Connector Nut counterclockwise one to two
turns until it is snug against the Lower Tension Cable.
Plug the Reed Switch Wire (3) into the Extension
Wire (15).
Making sure not to pinch any of the wires or
cables,
slide the Upright (2) onto the Frame (1).
Attach the Upright with three M10 x 25mm Button
Head Screws (25) and three Split Washers (69).
5. Attach the Upright Bracket (26) to the Upright (2) with
two M6 x 1Ó Hex Head Screws (27) and two 1/4Ó Split
Washers (62). The square hole must be on the left side.
Push the Handlebar Caps (28) onto the lower ends of
the Handlebars (10, 11). Align the indicated holes and
make sure that the frictions pads are on the side
shown. See drawing 5a. Apply a thin film of grease to
both sides of the Handlebar Caps.
Hold the lower end of the Left Handlebar (10) inside
of the Upright Bracket (26). Insert the M10 x 150mm
Carriage Bolt (32) into the Upright Bracket and
through the Left Handlebar. Hold the Right Handlebar
(11) inside of the Upright Bracket. Insert the Carriage
Bolt until the head of the Carriage Bolt is in the
square hole in the Upright Bracket. Slide the Star
Washer (29) onto the Carriage Bolt and tighten the
Resistance Knob (30) onto the Carriage Bolt.
See drawing 5b. Align the holes in the Handlebars (10,
11) with the hole in the Upright (2). Insert the Lock Pin
(31) through the Handlebars and the Upright.
Be care-
ful not to damage the wires inside the Upright.
5
27
62
26
32
2
28
Holes
Holes
Friction
Pad
Friction
Pad
29
11
30
10
4
74
74
1
76
76
75
75
25
25
69
69
2
15
3
4a
31
10
11
6. Connect the console wire to the Extension Wire (15).
Insert the Extension Wire and the console wire into
the Upright (2). Attach the Console to the Upright with
four M5 x 12mm Screws (33).
6
13
Console
Wire
33
2
33
15
28
5b
5a
28
Grease
