8
5. The Console (4) can be operated with four 1.5V
“D” batteries (not included); alkaline batteries are
recommended.
IMPORTANT: If the elliptical
exerciser has been exposed to cold tempera-
tures, allow it to warm to room temperature
before inserting batteries into the Console. If
you do not do this, the console displays or
other electronic components may become
damaged.
Remove the two screws from the
back of the console, and remove the battery
cover. Insert four batteries into the Console.
Orient the batteries as shown by the markings
inside the battery compartment. Then, reattach
the battery cover.
The Console (4) can also be operated with an
optional power supply (not included).
To pur-
chase a power supply, call the telephone
number on the front cover of this manual. To
avoid damaging the console, use only a
manufacturer-supplied power supply.
Plug
one end of the power supply into the jack on
the Console; plug the other end into an outlet
installed in accordance with all local codes and
ordinances.
5
6.
Tip: Be careful not to pinch the wires during
this step.
While a second person holds the Console (4)
near the Upright (2), connect the console wire to
the Wire Harness (49).
Attach the Console (4) with four M4 x 16mm
Screws (84).
6
4
4
2
84
96
84
49
Console Wire
Batteries
Battery
Cover
Screws
Avoid pinching
the wires during
this step
