7
6. Refer to the inset drawing. Insert the T-handle (4)
into the opening in the bottom of the Console (3) as
shown. Be careful not to pinch the console wire.
Align the holes in the metal tube on the T-handle
with the holes in the bracket on the Console.
Tighten two M4 x 12mm Screws (77) into the holes.
While another person holds the Console (3) near
the Upright (2), connect the console wire to the
Extension Wire (39). Insert the excess console wire
and Extension Wire into the Upright.
Attach the Console (3) to the Upright (2) with three
M10 x 22mm Button Screws (80) and three M10
Split Washers (54). Be careful to avoid pinching
the console wire or the Extension Wire (39).
Snap the bookrack onto the Console (3) in the loca-
tion shown.
6
5. The Console (3) requires four “D” batteries (not
included); alkaline batteries are recommended.
Press the tab on the battery cover, and lift off the
battery cover. Insert four batteries into the battery
compartment. Make sure that the batteries are
oriented as shown by the diagram inside the
battery compartment. Reattach the battery cover.
3
Battery
Cover
Batteries
5
7. Identify the Left Handlebar (7) and the Left
Handlebar Base (8), which are marked with stickers.
Attach the Left Handlebar to the Left Handlebar
Base with two M6 x 38mm Button Bolts (57) and
two M6 Nylon Locknuts (56).
Attach the Right Handlebar (not shown) to the Right
Handlebar Base (not shown) in the same way.
7
8
57
56
7
3
Bookrack
39
Console
Wire
Be careful
not to pinch
the console wire
during this step.
54
54
80
80
80
2
Bracket
Tube
77
77
4
3
