11.
Make sure that all parts are properly tightened before you use the treadmill.
Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill. If there is a sheet of
clear plastic on a decal, remove the plastic.
10.Lower the Uprights (111, 119) until the Handrails (108)
are touching the floor. Note: If necessary, pull out on the
latch knob so the pin does not hit the Frame (21).
See the lower drawing. Position the Uprights (111, 119)
so that the treadmill Frame (21) is centered between the
Uprights.
Firmly tighten the four Upright Bolts (133). Then, raise
the Uprights (111, 119) back to the vertical position.
Note: If necessary, pull out on the latch knob so the pin
does not hit the Frame (21).
Place the Weights on the Weight Rack.
133
111
119
10
111, 119
Latch
Knob
108
21
21
8. With the help of another person, hold the console assem-
bly near the Right Upright (119) and the left Upright (not
shown).
Connect the Wire Harness (118) to the wire harness in
the console assembly.
Make sure to connect the con-
nectors properly (see the inset drawing); the connec-
tors should slide together easily and snap into place.
If the connectors do not slide together easily and snap
into place, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Insert the excess wire harness
back into the right Handrail (108).
Set the console assembly on the Right Upright (119) and
the Left Upright (not shown) so it fits
over
the small tabs
on the Handrails (108).Thread two 1/4” x 1” Bolts (117)
with 1/4” Star Washers (136) into each side of the con-
sole assembly.
After you have started all four Bolts,
tighten them.
119
108
Console
Assembly
118
136
117
8
9. Attach the Weight Rack (2) to the Left Upright (111) and
the Right Upright (not shown) with four Rack Bolts (55)
and four Rack Nuts (57). Note: Be sure to orient the
Weight Rack with the bolt holes toward the indicated
bend in the Uprights.
2
111
55
Bend
57
9
9
Tab
Right
Handrail
