2. Using a rubber mallet, tap the Lock Knob Sleeve (91)
into the large hole in the left Upright (114). Align the two
small pins on the Lock Knob Spacer (75) with the small
holes in the left side of the Upright. Insert the Lock Knob
Spacer into the Upright. Make sure that the Lock Knob
Sleeve and the Lock Knob Spacer are fully inserted into
the Upright.
Remove the Lock Knob (90) from the Lock Pin (94).
Make sure that the Lock Pin Collar (93) and the Spring
(92) are on the Lock Pin. Insert the Lock Pin into the left
Upright (114) and tighten the Lock Knob onto it.
92
94
91
90
114
2
ASSEMBLY
Assembly requires two people.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires a rubber mallet
and a phillips screwdriver (not included).
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (114) until the treadmill is in the position shown.
Remove the EKG decal from the right grip pulse and
discard.
Note: One replacement Bumper (116) is included. If a
Bumper becomes worn and needs to be replaced, use
the replacement Bumper.
4.
Make sure that all parts of the treadmill are tightened before you use the treadmill.
Keep the included
allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect
the floor or carpet from damage, place a mat under the treadmill.
114
1
93
75
71
72
Ridges
6
79
3
3. Observe the two Rear Feet (72) at the rear of the tread-
mill (see figure 1 above). If there is a space between the
right Rear Foot and the floor, the Foot Spacer (71) will
need to be moved from the left Foot to the right Foot.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 18.
Using a phillips screwdriver, remove the Screw (6), Rear
Foot (72) and the Rear Foot Spacer (71) from the left
side. Remove the Rear Foot from the right side. Snap the
Rear Foot Spacer (71) onto the right Rear Foot. Reattach
the Rear Feet to the treadmill Frame (79).
Hold the treadmill firmly with both hands, and lower the
treadmill as described on page 18.
72
116
Remove
EKG
decal
72
6
