10
13.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages
20 and 21).
12. Raise the Frame (53) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Latch Assembly (55) so that the large
barrel and the Latch Knob (54) are in the posi-
tions shown. Attach the Latch Bracket (68) to the
bracket on the Base (80) with two 3/8" x 2" Bolts
(4) and two 3/8" Nuts (8).
Attach the upper end of the Latch Assembly (55)
to the bracket on the Frame (53) with a 3/8" x 2"
Bolt (4) and a 3/8" Nut (8). Note: It may be nec-
essary to move the Frame back and forth to
align the Latch Assembly with the bracket.
Lower the Frame (53) (see HOW TO LOWER
THE TREADMILL FOR USE on page 18).
55
8
8
Large
Barrel
68
80
4
53
12
4
54
11. Identify the Latch Assembly (55). Remove the
tie from the end of the tube. Make sure that the
sleeve has been slid over hole 1 and that the
Latch Knob (54) is locked into hole 1.
Pull on
the sleeve to make sure that it is locked into
place.
11
54
Sleeve
Hole 1
Tube
55
