ProForm XP 580s CrossTrainer, User Manual

Locate the Reed Switch (63) and the Magnet (46) on
the left side of the Pulley (47). Turn the Pulley until
the Magnet is aligned with the Reed Switch. 

Make

sure that the gap between the Magnet and the
Reed Switch is about 1/8”.

If necessary, loosen the

Screw (7), move the Reed Switch slightly, and then
retighten the Screw. Reattach the Hood, and run the
treadmill for a few minutes to check for a correct
speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION:

a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be-
come damaged. Remove the key and 

UNPLUG THE

POWER CORD

. Using the hex key, turn both rear

roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 2 to 3 inches off
the walking platform. Be careful to keep the walking
belt centered. Then, plug in the power cord, insert the
key, and run the treadmill for a few minutes. Repeat
until the walking belt is properly tightened.

c. If the walking belt still slows when walked on, please call toll-free 1-800-4-MY-HOME

®

(1-800-

469-4663).

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:

a.

If the walking belt is off-center,

first remove the key

and 

UNPLUG THE POWER CORD

.

If the walking

belt has shifted to the left,

use the hex key to turn

the left rear roller bolt clockwise 1/2 of a turn; 

if the

walking belt has shifted to the right,

turn the bolt

counterclockwise 1/2 of a turn. Be careful not to over-
tighten the walking belt. Then, plug in the power cord,
insert the key, and run the treadmill for a few minutes.
Repeat until the walking belt is centered. 

b.

If the walking belt slips when walked on,

first re-

move the key and 

UNPLUG THE POWER CORD

.

Using the hex key, turn both rear roller bolts clock-
wise, 1/4 of a turn. When the walking belt is correctly
tightened, you should be able to lift each side of the
walking belt 2 to 3 inches off the walking platform. Be
careful to keep the walking belt centered. Then, plug
in the power cord, insert the key, and carefully walk
on the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.

b

a

Rear Roller Bolts

2”–3”

b

Top 

View

19

46

7

63

1/8”

47