7
Apply Rim Height Sticker
Use a tape measure to crank rim
up to exactly 10' from playing
surface. Make a line mark on the
Actuator (B) against bottom
edge of Actuator Sleeve (C).
Crank the rim all the way down to
the extreme end. Peel and apply
Rim Height sticker to outside of
Actuator (B) lining up the mark
with the 10' mark on the Rim
Height
Sticker.
The Sticker may need
to be trimmed to clear the
Actuator Sleeve.
See Detail
A.
10ft
Rim Height
sticker
Actuator sleeve (C)
Attach Goal (K) to Backboard (G).
Remove the Rim box cover, put Goal
against Rim pad (Pre-installed), secure it
with 4 Carriage bolts M10x50 (#R1), 4 Flat
washers M10 (#R2), 4 Flange nuts M10
(#R3) See
.
Figure 6
Tighten all four bolts and nuts.
Put Rim box cover back and secure it with
removed screws.
9.
10.
R1
R2 R3
K
G
Figure 6
Figure 7
NOTE: Use a level to make sure rim is level side to side
before tightening nuts.
