6. Right/Left Handrail Arms and Computer Installation:
Step V:
Insert the Right Handrail Arm (2) onto the Right Handrail (9) and secure with
two M8 Bolts (36) and two Spring Washers (80). Using a #6 Allen wrench, tighten
the bolts until firm.
Step W:
Repeat step above for the left side.
Step X:
Install four M8 Nut Caps (95) onto the pre-welded nuts on the Right and Left
Handrails (9, 90).
Step Y:
Connect the Extension Sensor Wire (10) coming out from the top
side of the Hand Pulse Handlebar Support Frame (41) to the wire with a male
connector coming out from the Computer (29). Make sure the connectors
“click” when connected.
Connect the two Hand Pulse Sensor Wires (35) from the handlebars to the
two wires with female connectors coming out from the Computer (29). Make
sure the connectors “click” when connected.
Step Z:
Place the Computer (29) onto the plate of the Hand Pulse Handlebar
(33) then slide it down to lock in position.
Hardware:
Tool:
#6 Allen Wrench
29
90
2
9
95
95
77
36
80
80
36
35
10
33
(36) M8x35 Bolt
4 PCS
(80) Ø8 Spring Washer
4 PCS
(95) M8 Nut Cap
4 PCS
Right/Left Handrail Arm Hardware (Step V & W)
(Step X)
16
ASSEMBLY
