2. Handrails, Foot Bars and Rotation Rod Installation:
Position the
Right Foot Bar (17)
so that it angles downwards as shown above. Attach the
Right
Foot Bar (17)
onto the brackets on the bottom end of the
Right Handrail (9)
with one
Bolt (11)
and
one
Nylon Nut (14)
. Tighten the bolt until it is firm against the bracket on the
Right Handrail (9)
.
Cover the
Bolt (11)
and
Nylon Nut (14)
with two
Nut Caps (88)
.
Using the provided
6mm Allen Wrench
, remove the PRE-ASSEMBLED bolts and washers from
both sides of the
Rotation Rod (60)
and put them to the side
.
Take the
Rotation Rod (60)
and
lubricate it with the
Grease
provided.
Insert the
Rotation Rod (60)
into the tube on the top of the
Mainframe (59)
(above the flywheel).
Slide the
Right Handrail (9)
onto the right end of the
Rotation Rod (60)
and insert a
Bolt (5)
,
Spring Washer (6)
,
Washer (7)
, and
Waves Washer (22)
on to the right end of the
Rotation Rod
(60)
. Do not tighten the Bolt (5) until both handrails have been mounted to the
Rotation Rod (60)
.
Repeat the steps above for installing the Left side parts
(75)
, and
(77)
onto the
Rotation Rod (60)
.
Use both the
6mm Allen Wrench
and the
6mm Allen Wrench
with a Phillips Screwdriver
to
secure the
Bolts (5)
on both ends of the
Rotation Rod (60).
Tighten the both
Bolts (5)
at the same
time until firm and secure.
Hardware:
(11) Bolt
2PCS
(14) Nylon Nut
2PCS
(88) Nut Cap
4PCS
11
Tools:
6mm Allen Wrench & 6mm Allen Wrench
with Phillips Screwdriver
ASSEMBLY
Summary of Contents for 300LS
Page 5: ...LABEL PLACEMENT 3...
Page 7: ...5 OVERVIEW DRAWING...
Page 10: ...HARDWARE TOOLS PACK 8...