4. Foot Pedal Support Bracket and Left
Crank Bolt Installation:
Attach the
Foot Pedal Support Bracket
(18)
onto the left side of the
Left Foot Bar (76)
using two
Bolts (23)
, two
Washers (24)
, and two
Nylon Nuts (25)
. Use the
Open-Ended Flat Wrench
and
6mm Allen Wrench
to tighten the
Foot Pedal Support Bracket
(18)
to the
Left Foot Bar (76)
.
Lubricate the
Left Crank Bolt (64)
with some of the grease provided. Insert the
Left Crank Bolt
(64)
and one
Wave Washer (22)
through the left holes of the
Left Foot Bar (76)
. Raise the rear
end of the
Left
Foot Bar (76)
and align it with the threaded hold of the
Left Crank (75)
.
Make sure the
Left Crank Bolt
(64)
is level and straight as you insert it through the threaded
hole
of the
Left Crank (75)
. Turn the
Left Crank Bolt (64)
counter-clockwise
by hand until it is
firm. After hand tightening, completely tighten the
Left Crank Bolt (64)
with the
8mm Allen
Wrench
provided. Put one
Spring Washer (27)
and one
Left Nylon Nut (87)
on to the threaded
end of the
Left Crank Bolt (64)
. Use the
Open-Ended Wrench
on the
Left Nylon Nut (87)
and the
8mm Allen Wrench
on the
Left Crank Bolt (64) simultaneously to
tighten the
Left Nylon Nut
(87).
Cover the
Left
Nylon Nut (87)
with one
Cap (97)
.
Read the note on next page regarding tightening guidelines. Refer to the illustration
showing the correct installation of the Left Crank Bolt (64). See Figure F on the next page.
14
L for left bolt
Important:
Installing left bolt into left
crank can only be done
by turning left
(COUNTER-CLOCKWISE).
Tools:
6mm Allen Wrench
Open-Ended Flat Wrench
8mm Allen Wrench
ASSEMBLY
Summary of Contents for 300LS
Page 5: ...LABEL PLACEMENT 3...
Page 7: ...5 OVERVIEW DRAWING...
Page 10: ...HARDWARE TOOLS PACK 8...
