(58) Nut
2PCS
10. Computer Console Installation:
Connect the
Extension Sensor Wire (10)
coming out from the top side of the
Hand Pulse
Handlebar Support Frame (41)
to the wire with a male connector coming out from under the
Computer Console (29)
. Make sure the connectors “click” when connected. Connect the
two
Hand Pulse Sensor Wires (35)
coming out from the
Hand Pulse Handlebar (33)
to the two wires
with female connectors coming out from the
Computer Console (29)
. Make sure the connectors
“click” when connected. Attach the Computer Console (29) firmly by sliding the back of the console
onto the
Tab
located on the top of the
Hand Pulse Handlebar (33)
then slide it down to lock in
position. See illustration above.
Remove the
Nut (58)
from the
Adjustable Leveler (57)
. Screw the leveler onto the bottom of the
Mainframe (59)
and reinstall the
Nut (58)
by hand-tightening the nut on to the leveler. Repeat this
for the left side.
IMPORTANT:
To prevent the elliptical from wobbling during a workout, make sure you adjust the
levelers as instructed on
page 26.
Tools:
Open-Ended Flat Wrench
(57) Adjustable
Leveler
2PCS
Hardware:
22
21
ASSEMBLY
Summary of Contents for 300LS
Page 5: ...LABEL PLACEMENT 3...
Page 7: ...5 OVERVIEW DRAWING...
Page 10: ...HARDWARE TOOLS PACK 8...
