12
ASSEMBLY
STEP 3
3A Foot Pedal Support Bracket and Right
Crank Bolt Installation:
Attach the
Foot Pedal
Support Bracket
(18)
onto the right side of the
Right Foot Bar (17)
using two
Bolts (23)
, two
Washers (24)
, and two
Nylon Nuts (25)
. Use the
Open-Ended Flat Wrench
and
6mm Allen
Wrench
to tighten the
Foot Pedal Support Bracket
(18)
to the
Right Foot Bar (17)
.
3B
Inserting The Right Crank Bolt Through The Right Foot Bar:
Lubricate the
Right Crank
Bolt (21)
with some of the
Grease
provided. Insert the
Right Crank Bolt (21)
and one
Wave
Washer (22)
through the outside holes of the
Right Foot Bar (17)
.
3C Installing The Right Crank Bolt:
Make sure the
Right Crank Bolt
(21)
is perfectly level and
straight as you insert it into the
Right Crank (26),
through the
Right Foot Bar (17)
in a
CLOCKWISE direction. Use the
8mm Allen Wrench
to tighten the
Right Crank Bolt (21)
. Put one
Spring Washer (27)
and one
Right Nylon Nut (28)
onto the threaded end of the
Right Crank Bolt
(21)
in a COUNTER-CLOCKWISE direction. Use the
Open-Ended Wrench
on the
Right Nylon
Nut (28)
and the
8mm Allen Wrench
on the
Right Crank Bolt (21)
simultaneously to tighten the
Right Nylon Nut (28).
Cover the
Right
Nylon Nut (28)
with one
Nut
Cap (97)
.
Read the note on next page regarding tightening guidelines. Refer to the illustration
showing the correct installation of the Right Crank Bolt (21). See Figure A on the next page.
Important:
Installing right bolt into right
crank can only be done by
turning right (CLOCKWISE).
R for right bolt
TOOLS
6mm Allen Wrench
Multi-Hex Tool With
Phillips Screwdriver
Open-Ended Flat
Wrench
8mm Allen Wrench
Summary of Contents for Air Elliptical 1307
Page 5: ...3 LABEL PLACEMENT...
Page 8: ...6 OVERVIEW DRAWING...
Page 11: ...9 HARDWARE TOOLS PACK...
