REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER R2 10
SERVICE MANUAL
SETTING (point of balance)
STANDARD REAR UNIT
E
D
A
A
B
A
C
(V2)
C
V1
F
Front clamp
F
Axle with threaded rivet fixing with nut
X
A
G
(V2)
Thanks to a sliding system, you can adjust the setting of the wheelchair every millimetre.
Remove the bolt/washer
V2
and swing the side guard up until you can get access to the clamp
A
of
the post
B
.
Loosen the two grab screws
C
of the clamp
A
.
Loosen the bolt
D
and the two nuts
E
that you find on the inner side of the clamp
A
.
Repeat the same operation on both sides of the wheelchair.
Loosen the bolt
V1
that fixes the front clamp
F
that is also the brake support, of both sides of the
wheelchair. Note: the bolt is screwed into a threaded rivet fixed to the front axle, or, if the front axle is
not present, that bolt is screwed into a nut.
Slide the clamps
A
frontward or backward along the frame. If the tyre touches the brake, move
the front clamps forward. It may be possible to scratch the frame, so it is advisable to proceed
with care without forcing the system.
Once you reach the necessary setting, tighten the two nuts
E
first, then the bolt
D
and finally
the grab screws
C
of one clamp
A
.
Before fixing the other side, make sure the two clamps are at the same distance.
A good reference point is the distance
X
, from the rear side of the clamp
A
to the bolt
G
that
fixes the backrest plate.
It is advisable to spread a drop
of mild lock thread glue on the
on the grab screws
B
.
Now, swing the side guard down and slide it along the frame (the front clamps are still loosened) until aligning the hole with the threaded
one of the clamp and fix it with the bolt/washer
V2
. WARNING: fit the bolt V2 with care to prevent damaging the thread of the threaded hole.
Repeat the same operation on the other side and finally fix the bolt
V1
of both sides
.
The fixed side guard does not need any modification; on the other hand, the removable side guard will have
to be adjusted (see sheet “
side guard adjustment
”). You do not need to adjust the brakes.
The predetermined settings that appear in the order form have the following distance
S
(from the backrest’s
axis to the wheel’s axis)
:
Prudential 9.0 cm; Standard 10.5 cm; Active 12.0 cm; Extreme 13.5 cm.
Following the instruction above, you can reach a particularly prudential setting approx. 5 cm (distance
X
= 0,
rear clamp in contact with the backrest plate).
Remember that the setting adjustment can affect the
seat inclination, so it is necessary to check and adjust the
fork angle.
V1 V2
S
