REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER R2 11
SERVICE MANUAL
SETTING (point of balance)
FULL CARBON SIDE PLATES
Loosen the bolt
C
of the rear clamp
D
on both plates.
Slide the frame frontward or backward through the clamps to the desired position.
If the frames are too hard to move, loosen the bolts as much more as it is necessary.
It may be possible to scratch the frame, so it is advisable to proceed with care without
forcing the system.
It is possible to adjust the setting every millimetre.
Once reached the desired setting, tighten the bolts
A
and
C
on one side first. Then,
from the inner side of the frame, measure the distance
X
between the rear side of the
rear clamp and the backrest plate. Adjust and fix the other side respecting the same
distance.
When tightening each bolt, check that the inner plate of the clamp does not turn (you
can hold it with your fingers), in fact, if it turns, the clamp will not take hold of the frame properly.
Remember that the setting adjustment can affect the seat inclination, so it is necessary to check and adjust the fork angle.
The predetermined settings that appear in the order form have the following distance
S
(from the backrest’s
axis to the wheel’s axis)
:
Prudential 9.0 cm; Standard 10.5 cm; Active 12.0 cm; Extreme 13.5 cm
Following the instruction above, you can reach a particularly prudential setting approx.
5 cm (distance
X
= 0, rear clamp in contact with the backrest plate).
A
B
A
B
Front clamp
B
Axle with threaded rivet fixing with nut
B
D
C
X
D
S
A
C
Remove the rear wheel.
Loosen the bolt
A
of the front clamp
B
and put the wheel back on.
Note: the bolt is screwed into a threaded rivet fixed to the front axle, or, if the front axle is not present, that bolt is screwed into a nut.
Repeat the same operation on both sides of the wheelchair.
