REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 13
SERVICE MANUAL
DIRECTIONALITY
Mounting back the fork of the system V-Design 2.0.
Once you have casted the inserts
C0
or
C2
, it is advisable to try to screw the
bolt
F
to check there is no difficulty. Sometimes, in fact, the holes of the inserts
may have working burr that make the bolt hard to go through.
To mount the fork unit. Insert the axle
P
in the fork support paying attention to
the orientation of the same axle. In fact, the axle is not straight, but it shows a
bend.
Such bend must be facing to the rear of the wheelchair.
Insert and screw the bolt
F
without tightening it much (it is enough to screw it
up to stop).
Adjust the fork angle
—
see sheet “fork angle 4”.
Note.
This type of adjustment can take place even at original assembly, therefore,
you may find the inserts
C0
on one axle and
C1
on the other, for instance.
The wheelchair is not supplied with supplementary inserts, therefore, it will be
necessary to order them when needed.
For the adjustment of the fork angle and the removal of the fork support,
see chapters “fork angle” and “fork support position”
F
P
C0
or
C1
C0
or
C1
SIDE VIEW
P
REAR FRONT
C0
or
C1
Axles without inserts
Until 2019 the axles had no inserts
C0
or
C1.
There were 0°, 1°rh and 1°lh axles. To
adjust the directionality, it is necessary to
change the axle.