REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 14
SERVICE MANUAL
REAR HEIGHT
Adjustment every 1 cm.
Remove the bolt
A
on both sides of the wheelchair. The inner plate of the clamp-
support
B
and the nut will come off.
Move the frame up or down until aligning the hole of the support
B
with one of those
of the plate
C
.
Then insert the bolt
A
, the inner plate and the nut in its location.
When tightening this bolt, check that the inner plate of the clamp does not turn (you
can hold it with your fingers), in fact, if it turns, the clamp will not take hold of the
frame properly.
Finally tighten the bolt.
There is no need to use a spanner to hold the nut; in fact, its location on the inner
clamp will hold it.
Check/adjust the brakes.
Remember that the rear height adjustment can affect the seat inclination, so it is
necessary to check and adjust the fork angle.
The rear height adjustment can also change the point of balance (setting) of the
wheelchair.
If necessary, adjust the setting.
When increasing the rear height by two or more positions, it may be necessary to cut
off a little part the rear bottom side of the side guard, or reshape its bottom curve.
That is to avoid interference with the two bolts at the back of the frame and/or with
the support
B
.
When decreasing the rear height, the gap between side guard and frame will in-
crease, but there is no need to modify the side guard.
Should the side plate be Full Carbon (with integrated side guards), the adjustment is
the same, but with the advantage that, regardless the rear height you choose, you
will never modify the side guard.
C
B
A
Inner plate of the
clamp
Nut
B
Possible side
guard cut
A
Full Carbon plate
Part leaning
against the plate
Inner
plate
B
