REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 15
SERVICE MANUAL
SETTING (point of balance)
Remove the rear wheel.
Loosen the bolt
B
of the front support and put the wheel on.
Repeat the same operations on the other side of the wheelchair.
Loosen the bolt
A
of the rear support of both plates
C
.
There is no need to use a spanner to hold the nut; in fact, its location on the inner clamp will hold it.
The front supports integrate the brake clamp and they also fix the front axle. The front axle is not
necessary if the seat is of the type ” rigid in carbon fibre”.
Slide the frame frontward or backward through the clamps to the desired position
.
If the frames are too hard to move, loosen the bolts as much more as it is necessary.
It is possible to adjust the setting every millimetre.
Once reached the desired setting, tighten the bolts
A
and
B
on one side first
.
Then measure the distance
X
between the rear side of the rear support and the bolt
E
.
Adjust and fix the other side respecting the same distance.
When tightening each bolt, check that the inner plate of the clamp does not turn (you can hold it with
your fingers), in fact, if it turns, the clamp will not take hold of the frame properly.
It may be possible to scratch the frame, so it is advisable to proceed with care and do not force the
system.
Remember that the setting adjustment can affect the seat inclination, so it is necessary to check
and adjust the fork angle.
The predetermined settings that appear in the order form approximately have the following distance
D
(from the backrest’s axis to the wheel’s axis):
Prudential 9.0 cm; Standard 10.5 cm; Active 12.0 cm; Extreme 13.5 cm
Following the instructions above mentioned, you can reach a particularly prudential setting up to 5
cm (with distance
X
= 0, rear support in contact with the bolt
E
).
With the Full Carbon plate (with integrated mud guards), the adjustment is the same. It results easi-
er to take the measure
X
from under the seat, between the inner plate of the rear support and the
backrest plate.
C
D
A
B
Full Carbon plate
B
A
X
Inner plate
of the rear support
with embedded nut
X
E
The front support integrates the
brake clamp and fixes the front axle
